Pursuit 3070, garmin 1243

I recently purchased my first real boat, a Limestone Cuddy 24 with a 350 inboard. The first few trips were amazing. We were even successful on the first salmon fishing attempt. However… today did not go as well.

I pulled out of the marina on the boat slowly at about 1,000 RPM. Once I was outside of the marina, I went to accelerate and had no response from the throttle, with the boat remaining at 1,000 RPM despite how far down I pushed the throttle.

I then turned the engine off, turned it back on, and then it ran okay for a few minutes at 2900rpm. Then I had a loss of power down to 2000rpm. I then dropped it to 1200 to make my way back. At one point I put it in neutral, at which point it would rev between 600 and 1000 rpm.

Fuel delivery, ignition, or an engine-control fault? Suggestions for where to start?

Appreciate any ideas. Thanks!

Looking to purchase this boat in Ontario for $24k it’s a 18’ 2009 legend Excalibur with a 2009 mercury 2 stroke. Comes with fish finder, cb radio, and a trolling motor that is currently not working. Any opinions/advice is greatly appreciated.
Did take out on water for testing seems to work just fine.

I got this project a while back and only just got around to really putting time into it, I noticed the transom is definitely rotted. How should I tackle this? The boat was 1k so I don’t wanna empty my wallets on it, but I just got the 1981 Evinrude 60hp idling and running great. It’s a 16ft fiberglass hull I would have to find someone with an engine hoist as I do not have one

Got a Predator 670 22 HP on a GoDevil Long Tail kit on a 1436 Aluminum Jon boat. The throttle doesn’t want to stay consistent it’s like a galloping rhythm like a horse. Tried adjusting the carb with no luck anyone know what might be going on here? Thanks.

I have aquired a Starcraft SuperSport 16. This item is mounted on the inside of the gunnels. I am stumped as to their purpose. Anybody have an idea?

My Boat Photon Therapy now has over 1700 miles and 72 hours underway on the sea. Powered by the sun, silent, no vibration:)

Looking for a 35-45ft motor yacht to live aboard at a marina, drive out once or twice a week on the weekends. Currently own a 21ft with a small cabin to get used to driving and owning a boat etc…

Budget around 150k for two people with a small dog.

Favourites so far: Silverton 35 motor yacht and cruisers yacht 3750.

Any recommendations? TIA🙏

EDIT: thanks for all the tips already, we do have a slip available for live aboard.

[ Removed by Reddit on account of violating the content policy. ]

I'm planning a week of sailing around the Cyclades in Greece in November, on a 40ft monohull starting from Lavrio. I'm thinking of stopping at Kea, Kythnos, Serifos, Syros and Tinos before heading back. I'd like to visit some small villages and find nice anchorages along the way.

for those who've sailed around the Cyclades in November, would you try to visit all these islands in a 7days trip?

- are the ports on these islands still open?

- would you plan night stops in advance?

- any passages along this route you'd avoid in November?

Thanks!

I grew up boating with my dad and friends and have spent endless hours on boats. I finally made the leap and purchased my own.

It’s a 1997 hydra sport 20 foot center console. It has a 2024 Suzuki 175 on it with 55 hours. The boat sat quite a bit the last year or so according to the previous owner so I took it in to an authorized Suzuki dealer and had a full service done on the motor. They said the motor looks perfect and is as good as new. I walked and knocked on every inch of the boat and it has zero soft spots. I also tugged on the motor and there was no flex or movement in the transom. It has a 85 gallon poly tank that seems to be in good shape.

The trailer needs new bunk carpet, wheels and hubs. There is a good bit of spider cracks on the hill but that is to be expected on a 30 year old hull. Because it’s old school wood construction I do have some worries about rot. I was able to get a hand on two stingers and they felt solid though there was a fair bit of moister in the hull.

Is there anything I should be doing to help avoid rot? If anyone has experience with the hull, how did you like it? Pros and cons?

With all that being said I feel pretty good about the purchase. I paid $11k. So basically buy and motor and get a hull for free.

Anyone aware of a cover for these? I know I can buy a new block with ones that have it, but didn’t want to go that way if I didn’t have to.

I have a few empty switches and want to add Active Target Module. How do I wire it to switch?

When I go to change the lower unit gear lube to winterize my engine. Should I order this black seal or the red seal to replace? Last year when I did it I just re used the same seal that was already on there so figured I should replace it this time. But can’t remember if it has the black seal, the red seal, or both. 2003 Mercury 40hp 2 stroke

2003 Mercury 40hp 2 stroke. Looking to order a fuel pump diaphragm kit. Trying to determine the correct part number in the manual.

How can I confirm which fuel pump version I have?

Scrolling FBM as one does and I came across this 39 ft cat, and I have never seen outdrives like this? I’m in the southwest and we have the more typical inboard outboards. What is the benefit to this type? Does it handle better? Is it more common for off shore boats?

This is Florida by the way.

Does anyone use Chubb for your boat insurance? Im shopping around and I noticed that they're considerably cheaper than the major providers. For those that have Chubb, any issues with any filed claims?

Canbat batteries in Vancouver.. Anyone have any experience with them. Reviews and specs seem great but the batteries seem to be cheaper then the alternatives. Specifically looking at ordering 6 6v GC2 200ah AGMs ($256) to replace a set of lead acids that are acting up.. As well, my lead acids a pair of them are setup as my starter bank. however, i don't see CCA ratings for my lead acids or the canbats. Does that matter, should i be concerned they won't handle the cranking. I have a westerbeeke 33 and I have sent this inquiry to them. Just curious if others have AGM knowledge they can share to help me better make a decision. Are interstates ($567) really worth $300 more a piece?

Got the boat lifted yesterday after a couple of months in freshwater, usually in seawater. It was last out in April when it was recently antifouled and no signs of this then.

I’m gonna be buying my first boat. How concerned should I be when there is a faint fuel smell in the rear compartment of a boat? I’m looking at mostly boats with an outboard. But two so far have had the smell. It’s in compartments where the fuel filter, hoses are. These boats are 10-20 years old, so I can’t expect them to be perfect. Just want to avoid safety issues, or very large expense repairs

I have a pontoon push boat that I use to push around my 16x32 barge.m sometimes has a track hoe on it. Weighs about 25-40k lbs

I have a 115 Yamaha 4 stroke What’s the most aggressive/torque prop I can put on it?

Hi everyone! Was just hoping for some advice/ recommendation.
I have a Vitrifrigo fridge in the boat I’m staying on and have accidentally poked a hole in the evaporator plate (small black dot in attached picture)

I have reached out to a few marine specific mechanics and also general appliance mechanics. I have accepted it won’t be a cheap fix 😅 but would love to not have to replace the whole unit.

I found the part online that needs to be replaced, but no one seems that keen on taking the job on.

Has anyone had this or a similar issue happen and had been able to repair? I’m struggling to accept having to buy a whole new one!!

Thank so much!!