What is the correct torque? My Haynes manual says 80, pelican parts says 75+5 and I'm seeing straight 75 other places online. Can anybody clear this up for me?

My climate control Bottom lever isnt going into the Hot part only stays in the middle/cold and it feels jammed when i try to pull it to the right/heat

I finally pulled the trigger to carbon overlay my wing. The original concept was to do it, get everyone involved to sign the wing, then first coat. But that kinda fell apart. I'm just trying to avoid creators block as in genuinely stuck on how to do the taillights.

I have been dealing with cam tower gaskets blowing out, including the foam covered LR aluminum one. I took a close look at both surfaces and the head side looks to have a few burrs and scratches on the edge that need to be taken down. Is a foam block with sandpaper the safest way for me to knock these down? I really don’t want to remove this head and take it to a machine shop as it is very costly. I have a replacement paper gasket to put on it so if I need to use a sealant please let me know.