r/ps2 • u/Tahu-bannana-69 • 20h ago

Should I fix this?

Gallery image

Gallery image

Gallery image

It dose not look that bad but i don’t want my games to get scratched I heard I could just tape it down but is that really ok for the ps2? What should I do leave it or fix it thanks!

7 Upvotes

100% Upvoted

6 comments sorted by

7

u/The-Huntsman01 20h ago

Yes. Yes you should

2

u/Tahu-bannana-69 20h ago

How should I do it is it ok just to tape it down

4

u/Consistent-Doubt-287 20h ago

Very carefully, with tweezers, put a piece of electrical tape on the bottom part of the ribbon cable to help hold it down. Don't need to put a ton of it in there, just enough to take the slack and there should still be plenty left for the laser to move without any issue.

1

u/AutoModerator 20h ago

Hello u/Tahu-bannana-69 and thank you for your submission on /r/ps2, our subreddit rules have updated recently so please make sure your post is not in violation and is in the appropriate place. All tech support questions should go into the Tech Support Megathread. It can be found stickied on the front page of /r/ps2.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

2

u/RedGodzilla7 13h ago

Yep that ribbon is sitting way too high. It you leave it unchecked it will ruin your discs.

Remove the back section of the PS2, take the lid off and then put some electrical tape down to help it stay down.

It’s an easy fix should take around 10 mins.

0

u/Ombaragundon 15h ago

This ps2 should have ethernet. Use OPL. Stop damaging your lens and discs