Wax assembled or split?

[u/thaneliness]

Getting my boards ready and curious if I should split my board when waxing or what the general consensus is?

[u/TooFarTurner]

I have done it both ways. I think as skis is a little easier.

[u/eatsdirtforlunch → u/TooFarTurner]

Same, I just split them apart when I wax.

[u/hardkn0cks]

Split.

[u/That-Bitter-Guy]

Split - I always scrap, brush, buff really well so I don't get tiny wax bits sticking to my skins.

[u/Boarder8350]

I think the flex between the two would make it a bitch to scrape, I’ve always waxed them split apart for that reason.

[u/staniel_mortgage]

I wax when split - just makes scraping a bit easier. Could always buff out together?

[u/sidewaysride]

Doesn’t matter while waxing but it will scrape easier split.

[u/candid_canuck]

Try it both ways and see what you prefer. No right or wrong on this one.

[u/RonShreds → u/candid_canuck]

There really is. Try scraping a splitboard.

[u/the_sodfather]

I don't have the downhill binding on when I wax, so the split isn't very rigid. Typically I wax them separately. I have dripped the wax and ironed them together but split for scrape and brush.

[u/letsbereasonable123]

If it's already assembled, ill wax on ssembled then split to scrape. If already split ill do the whole process split.

Scraping thoroughly is more important on a split as any excess wax can get stuck to your skin glue before the snow has a chance to take it off.

[u/VikApproved]

I'm going clean the edges and possibly repair/sharpen them so I want the board split when waxing.

[u/joeg170]

Split. That way you can make sure the inner edge is scraped of all wax

[u/buymeow]

Its in the name Spliddit